84721B
1.INSPECT PANORAMIC VIEW MONITOR SWITCH
Remove the panoramic view monitor switch
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SWITCH>REMOVAL
| *a | Component without harness connected
(Panoramic View Monitor Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 5 (D) - 2 (E) | Panoramic view monitor switch pushed | Below 1 Ω |
| Panoramic view monitor switch not pushed | 1 kΩ or higher |
If the result is not as specified, replace the panoramic view monitor switch.
Check that the switch illumination illuminates.
| *a | Component without harness connected
(Panoramic View Monitor Switch) |
Apply battery voltage to the panoramic view monitor switch and check that the switch illumination illuminates.
| Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 6 (ILL+)
Battery negative (-) → Terminal 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the integration control & panel assembly.
Install the panoramic view monitor switch.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SWITCH>INSTALLATION