Home › Engine / Hybrid System › 6AR-FSE (ENGINE MECHANICAL) › CYLINDER HEAD › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072202 6AR-FSE ENGINE MECHANICAL _0351459 CYLINDER HEAD A

6AR-FSE ENGINE MECHANICAL  CYLINDER HEAD  REPAIR  


PROCEDURE

Hide 11131 1.REPAIR INTAKE VALVE SEAT

NOTICE:
·

Repair the intake valve seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Release the cutter gradually to make the intake valve seat smooth.



a.
A194983

Using a 45° cutter, resurface the intake valve seat so that the intake valve seat width is more than the standard.


b.
A285334C17
2.719,1.656 3.031,1.813 0.313,0.156 10 false *a 3.115,0.521 3.406,0.844 0.292,0.323 10 false 30° 2.896,0.333 3.188,0.656 0.292,0.323 10 false 45° 2.646,0.167 2.938,0.49 0.292,0.323 10 false 60°
*a Width


Using 30° and 60° cutters, correct the intake valve seat so that the intake valve contacts the entire circumference of the intake valve seat. The contact should be in the center of the intake valve seat, and the intake valve seat width should be as specified around the entire circumference of the intake valve seat.

Standard Width:

1.0 to 1.4 mm (0.0394 to 0.0551 in.)



c.

Hand lap the intake valve and intake valve seat with an abrasive compound.


d.

Check the intake valve seating position.


Hide 11135 2.REPAIR EXHAUST VALVE SEAT

NOTICE:
·

Repair the exhaust valve seat while checking the seating position.

·

Keep the lip free from foreign matter.

·

Release the cutter gradually to make the exhaust valve seat smooth.



a.
A194982

Using a 45° cutter, resurface the exhaust valve seat so that the exhaust valve seat width is more than the standard.


b.
A124255C20
2.539,0.0 2.78,0.161 0.241,0.161 10 75° 2.943,0.105 3.184,0.266 0.241,0.161 10 45° 3.14,0.382 3.381,0.543 0.241,0.161 10 30° 2.831,1.726 3.08,1.91 0.249,0.183 10 *a
*a Width


Using 30° and 75° cutters, correct the exhaust valve seat so that the exhaust valve contacts the entire circumference of the exhaust valve seat. The contact should be in the center of the exhaust valve seat, and the exhaust valve seat width should be as specified around the entire circumference of the exhaust valve seat.

Standard Width:

1.2 to 1.6 mm (0.0472 to 0.0630 in.)



c.

Hand lap the exhaust valve and exhaust valve seat with an abrasive compound.


d.

Check the exhaust valve seating position.