| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Camshaft timing exhaust gear assembly x No. 2 camshaft | 85 | 867 | 63 | ||||
| No. 1 camshaft bearing cap, No. 2 camshaft bearing cap, No. 3 camshaft bearing cap and No. 4 camshaft bearing cap x Camshaft housing sub-assembly and Cylinder head sub-assembly | 27 | 275 | 20 | ||||
| No. 1 camshaft bearing cap, No. 2 camshaft bearing cap, No. 3 camshaft bearing cap and No. 4 camshaft bearing cap x Camshaft housing sub-assembly | 16 | 163 | 12 | ||||
| Camshaft timing gear bolt x Camshaft | Type A | 120 | 1224 | 89 | |||
| Type B | 95 | 969 | 70 | ||||
| No. 1 chain tensioner assembly x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| Timing chain cover plate x Timing chain cover sub-assembly | 10 | 102 | 7 | ||||
| Engine wire x Engine | A | 10 | 102 | 7 | |||
| B | 9.8 | 100 | 87 | ||||
| Fuel hose bracket x EGR valve bracket | 13 | 133 | 10 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Cylinder head sub-assembly x Cylinder block sub-assembly | Step 1 | 36 | 367 | 27 | ||
| Step 2 | 36 | 367 | 27 | |||
| Step 3 | Turn 90° | |||||
| Step 4 | Turn 90° | |||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Crankshaft pulley x Crankshaft | 260 | 2651 | 192 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Drive plate and ring gear sub-assembly x Crankshaft | 98 | 999 | 72 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| No. 1 engine hanger and No. 2 engine hanger x Cylinder head sub-assembly | 43 | 438 | 32 | ||||
| Engine mounting bracket sub-assembly LH x Vehicle body | 72 | 734 | 53 | ||||
| Engine mounting spacer x Vehicle body | 72 | 734 | 53 | ||||
| Engine mounting insulator sub-assembly RH x Engine mounting spacer and Vehicle body | 72 | 734 | 53 | ||||
| No. 1 bond cable x Engine mounting insulator sub-assembly RH | 9.5 | 97 | 84 | ||||
| Bracket x Engine mounting insulator sub-assembly RH | 8.0 | 82 | 71 | ||||
| Radiator reserve tank assembly x Vehicle body | 5.0 | 51 | 44 | ||||
| Rear engine mounting insulator x Rear engine mounting bracket | 72 | 734 | 53 | ||||
| Front engine mounting insulator x Front engine mounting bracket | 72 | 734 | 53 | ||||
| Front frame assembly x Front engine mounting insulator and Rear engine mounting insulator | 72 | 734 | 53 | ||||
| Front bumper extension sub-assembly RH and Front bumper extension sub-assembly LH x Front frame assembly and Vehicle body | Bolt (A) | 9.0 | 92 | 80 | |||
| Bolt (B) | 12.5 | 127 | 9 | ||||
| Bolt (C) | 135 | 1377 | 100 | ||||
| Front suspension member bracket sub-assembly RH and Front suspension member bracket sub-assembly LH x Front frame assembly and Vehicle body | Bolt (D) | 17.5 | 178 | 13 | |||
| Bolt (E) | 135 | 1377 | 100 | ||||
| Nut | 17.5 | 178 | 13 | ||||
| Rear No. 2 engine mounting insulator x Engine mounting bracket sub-assembly LH | 42 | 428 | 31 | ||||
| Engine mounting insulator sub-assembly RH x Engine mounting bracket RH | Bolt | 72 | 734 | 53 | |||
| Nut | 42 | 428 | 31 | ||||
| Wire harness x Vehicle body | 8.0 | 82 | 71 | ||||
| Wire harness x Engine room relay block and junction block assembly | 8.0 | 82 | 71 | ||||
| Wire harness x Vehicle body | 10 | 102 | 7 | ||||
| Transmission control cable assembly x Transmission control shaft lever | 12 | 122 | 9 | ||||
| Battery clamp sub-assembly x Rear No. 2 engine mounting insulator | 18.5 | 189 | 14 | ||||
| Wire harness x Positive (+) battery terminal | 7.6 | 77 | 67 | ||||
| Inlet air cleaner assembly x Vehicle body | 8.0 | 82 | 71 | ||||
| Front lower bumper absorber x Vehicle body | 7.5 | 76 | 66 | ||||
| Front fender apron seal LH x Vehicle body | 7.5 | 76 | 66 | ||||
| Front fender apron seal RH x Vehicle body | 7.5 | 76 | 66 | ||||
| No. 1 engine under cover x Vehicle body | 7.5 | 76 | 66 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Camshaft housing stud bolt x Camshaft housing sub-assembly | 6.5 | 66 | 58 | ||||
| Stiffening crankcase stud bolt x Stiffening crankcase assembly | Stud bolt (A) | 9.5 | 97 | 84 | |||
| Stud bolt (B) | 4.0 | 41 | 35 | ||||
| Engine balancer assembly x Stiffening crankcase assembly | 24 | 245 | 18 | ||||
| Stiffening crankcase assembly x Cylinder block sub-assembly | Bolt (A) | 24 | 245 | 18 | |||
| except Bolt (A) | 43 | 438 | 32 | ||||
| No. 1 oil pan baffle plate x Stiffening crankcase assembly | 10 | 102 | 7 | ||||
| Oil level sensor bracket x Stiffening crankcase assembly | 10 | 102 | 7 | ||||
| Oil strainer sub-assembly x Stiffening crankcase assembly | 9.0 | 92 | 80 | ||||
| Oil pan sub-assembly x Stiffening crankcase assembly | 10 | 102 | 7 | ||||
| Oil pan drain plug x Oil pan sub-assembly | 40 | 408 | 30 | ||||
| No. 1 camshaft bearing cap, No. 2 camshaft bearing cap, No. 3 camshaft bearing cap and No. 4 camshaft bearing cap x Camshaft housing sub-assembly | 16 | 163 | 12 | ||||
| No. 1 camshaft bearing cap, No. 2 camshaft bearing cap, No. 3 camshaft bearing cap and No. 4 camshaft bearing cap x Camshaft housing sub-assembly and Cylinder head sub-assembly | 27 | 275 | 20 | ||||
| Oil pipe sub-assembly x No. 4 camshaft bearing cap | 10 | 102 | 7 | ||||
| Camshaft timing exhaust gear assembly x No. 2 camshaft | 85 | 867 | 63 | ||||
| Camshaft timing gear bolt x Camshaft | Type A | 120 | 1224 | 89 | |||
| Type B | 95 | 969 | 70 | ||||
| No. 1 chain vibration damper x Cylinder head sub-assembly and Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| Chain tensioner slipper x Cylinder head sub-assembly | 21 | 214 | 15 | ||||
| No. 1 chain tensioner assembly x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| Timing chain guide x No. 1 camshaft bearing cap | 21 | 214 | 15 | ||||
| Case separator x Cylinder head cover case sub-assembly | 10 | 102 | 7 | ||||
| Cylinder head cover sub-assembly x Camshaft housing sub-assembly | 12 | 122 | 9 | ||||
| Crankshaft pulley x Crankshaft | 260 | 2651 | 192 | ||||
| No. 1 ventilation case x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| Engine cover joint x Cylinder head cover sub-assembly and Camshaft housing sub-assembly | 10 | 102 | 7 | ||||
| Stud bolt x Water inlet housing | Stud bolt (A), (B) | 4.4 | 45 | 39 | |||
| Stud bolt (C) | 4.0 | 41 | 35 | ||||
| Water inlet housing x Cylinder block sub-assembly | 43 | 438 | 32 | ||||
| Wire harness clamp bracket x Cylinder head cover sub-assembly | 10 | 102 | 7 | ||||
| No. 1 water by-pass pipe x Water inlet housing and Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| V-ribbed belt tensioner assembly x Water inlet housing | 21 | 214 | 15 | ||||
| No. 5 engine wire x Fuel delivery pipe | 10 | 102 | 7 | ||||
| Intake manifold x Cylinder head sub-assembly | 28 | 286 | 21 | ||||
| No. 1 compressor mounting bracket x Cylinder block sub-assembly and Stiffening crankcase assembly | 21 | 214 | 15 | ||||
| Drive shaft bearing bracket x Cylinder block sub-assembly | 63.7 | 650 | 47 | ||||
| for Type A:
Compressor assembly with magnetic clutch x No. 1 compressor mounting bracket |
Stud bolt | 10 | 102 | 7 | |||
| Bolt and Nut | 24.5 | 250 | 18 | ||||
| for Type B:
Compressor assembly with magnetic clutch x No. 1 compressor mounting bracket |
24.5 | 250 | 18 | ||||
| Wire harness clamp bracket x Cylinder head cover sub-assembly | 10 | 102 | 7 | ||||
| Wire harness clamp bracket x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| Wire harness clamp bracket x Water inlet housing | 10 | 102 | 7 | ||||
| Wire harness clamp bracket x Timing chain cover sub-assembly | 10 | 102 | 7 | ||||
| Exhaust manifold converter sub-assembly (TWC: Front Catalyst) x Cylinder head sub-assembly | 62 | 632 | 46 | ||||
| Engine oil level dipstick guide x Water inlet housing | 10 | 102 | 7 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Cylinder head stud bolt x Cylinder head sub-assembly | Stud bolt (A), (C) | 6.5 | 66 | 58 | |||
| Stud bolt (B) | 8.5 | 87 | 75 | ||||
| No. 1 straight screw plug x Cylinder head sub-assembly | 44 | 449 | 32 | ||||
| No. 2 straight screw plug x Cylinder head sub-assembly | 78 | 795 | 58 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt x Cylinder block sub-assembly | Stud bolt (A) | 6.5 | 66 | 58 | |||
| Stud bolt (B) | 8.5 | 87 | 75 | ||||
| No. 1 oil nozzle sub-assembly x Cylinder block sub-assembly | 10 | 102 | 7 | ||||
| Crankshaft bearing cap x Cylinder block sub-assembly | Step 1 | 20 | 204 | 15 | |||
| Step 2 | 40 | 408 | 30 | ||||
| Step 3 | Turn 90° | ||||||
| Connecting rod cap x Connecting rod | Step 1 | 40 | 408 | 30 | |||
| Step 2 | Turn 90° | ||||||