Home › General › MAINTENANCE › 6AR-FSE DRIVE BELT › 2018.04–2021.02
RM33A0E _V1 General _065356 MAINTENANCE _0351479 6AR-FSE DRIVE BELT A

MAINTENANCE  6AR-FSE DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL V-RIBBED BELT

HINT:

When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.


a.
A337564C01
0.896,0.948 1.531,0.948 false 0.781,3.115 0.781,2.656 false 3.104,0.615 2.906,0.615 false 3.052,1.51 2.854,1.51 false 3.063,2.5 2.865,2.5 false 0.719,3.135 1.031,3.292 0.313,0.156 10 false *1 0.708,0.875 1.021,1.031 0.313,0.156 10 false *2 3.146,0.531 3.385,0.729 0.24,0.198 10 false *3 3.104,1.438 3.344,1.656 0.24,0.219 10 false *4 3.094,2.427 3.302,2.677 0.208,0.25 10 false *5
*1 Crankshaft Pulley
*2 V-ribbed Belt Tensioner Assembly
*3 Generator Assembly
*4 Engine Water Pump Assembly
*5 Compressor Assembly with Pulley


Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.


b.

Loosen the V-ribbed belt by turning the belt tensioner clockwise.


c.

Set the V-ribbed belt onto the water pump pulley.

NOTICE:

Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.



d.
A314804C01
0.552,1.167 0.719,1.333 0.167,0.167 10 false *a 2.198,1.167 2.365,1.333 0.167,0.167 10 false *b
*a Correct
*b Incorrect


After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.