28150
1.REMOVE MAGNET STARTER SWITCH ASSEMBLY
Remove the nut and disconnect the field coil lead wire from the magnet starter switch assembly.
While holding the magnet starter switch assembly to the repair service starter kit, remove the 2 nuts.
| *1 | Magnet Starter Switch Assembly |
| *a | Pinion Drive Lever |
| *b | Hook |
While lifting the rear of the magnet starter switch assembly, remove the hook from the pinion drive lever, then remove the magnet starter switch assembly.
28120
2.REMOVE STARTER YOKE ASSEMBLY
| *1 | Starter Yoke Assembly |
| *2 | Starter Commutator End Frame Assembly |
Using a T25 "TORX" socket wrench, remove the 2 through bolts and pull out the starter yoke assembly together with the starter commutator end frame assembly.
3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY
| *1 | Starter Commutator End Frame Assembly |
| *2 | Starter Yoke Assembly |
Remove the 2 screws from the starter commutator end frame assembly.
| *1 | Starter Commutator End Frame Assembly |
| *2 | Starter Yoke Assembly |
| *a | Lead Wire Rubber |
Remove the starter commutator end frame assembly from the starter yoke assembly.
Make sure the lead wire rubber remains attached to the starter yoke assembly when removing the starter commutator end frame assembly.
28140
4.REMOVE STARTER BRUSH HOLDER ASSEMBLY
| *a | Brush Spring |
| *b | Brush |
Using a screwdriver, hold the brush spring back and disconnect the starter brush holder assembly.
Disconnect the 4 brushes, and remove the starter brush holder assembly.
28160
5.REMOVE STARTER ARMATURE ASSEMBLY
| *1 | Starter Yoke Assembly |
| *2 | Starter Armature Assembly |
Remove the starter armature assembly from the starter yoke assembly.
6.REMOVE STARTER ARMATURE PLATE
| *1 | Starter Armature Plate |
| *2 | Repair Service Starter Kit |
| *3 | Starter Yoke Assembly |
Remove the starter armature plate from the repair service starter kit or starter yoke assembly.
7.REMOVE RUBBER SEAL
Remove the rubber seal from the repair service starter kit.
8.REMOVE PLANETARY GEAR
Remove the 3 planetary gears from the repair service starter kit.