If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.
| DTC | Component | Fail-Safe Operation | Fail-Safe Deactivation Condition |
|---|---|---|---|
| P001100
P001500 |
VVT system | ·
Idle up (control of combustion decreased). ·
Fuel-cut control is stopped. |
Pass condition detected |
| P003012
P003013 P101A9E |
Air fuel ratio sensor heater | The ECM turns off the air fuel ratio sensor heater. | Engine switch off |
| P003612
P003614 P102A9E |
Heated oxygen sensor heater | The ECM turns off the heated oxygen sensor heater. | Engine switch off |
| P008700
P008800 P123513 |
Fuel pump with seal assembly (for high pressure side) | ·
The ECM performs fuel-cut when the engine speed and engine load are high. ·
Fuel pressure is set to 200 kPa (2 kgf/cm2, 29 psi). |
Engine switch off |
| P010012
P010014 |
Mass air flow meter sub-assembly | The ECM calculates fuel injection volume according to the engine speed and throttle valve position. | Pass condition detected and then engine switch turned off |
| P011011
P011015 |
Intake air temperature sensor (mass air flow meter sub-assembly) | The ECM estimates intake air temperature to be 20°C (68°F). | Pass condition detected and then engine switch turned off |
| P011511
P011515 |
Engine coolant temperature sensor | The ECM estimates engine coolant temperature to be 80°C (176°F). | Pass condition detected |
| P012011
P012015 P01201C P022011 P022015 P060444 P060604 P060629 P060647 P060A47 P060B49 P060D49 P060E49 P061E49 P065714 P06579E P160700 P210014 P210015 P211172 P211173 P211900 P211904 P211977 P21352B |
Electronic throttle control system | The ECM cuts throttle actuator current and the throttle valve is returned to a 7° opening angle by the return spring.
The ECM then adjusts the engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with the accelerator pedal angle to allow the vehicle to be driven at a low speed*. |
Pass condition detected and then engine switch turned off |
| P019011
P019015 |
Fuel pressure sensor (fuel delivery pipe sub-assembly) | ·
The ECM performs fuel-cut when the engine speed and engine load are high. ·
Fuel pressure is set to 200 kPa (2 kgf/cm2, 29 psi). |
Pass condition detected and then engine switch turned off |
| P020113
P020213 P020313 P020413 P062D13 |
ECM (injector driver) | The ECM performs fuel-cut when the engine speed is 2000 rpm or more. | Pass condition detected and then engine switch turned off |
| P032511
P032515 |
Knock control sensor | The ECM sets the ignition timing to maximum retard. | Engine switch off |
| P035113
P035213 P035313 P035413 |
Ignition coil assembly | The ECM cuts the fuel injection. | Pass condition detected |
| P040314
P140000 P140596 P141004 |
EGR valve assembly | The ECM assumes that the EGR valve assembly is closed and controls the ignition timing. | Pass condition detected and then engine switch turned off |
| P05042B | Stop light switch assembly | The accelerator pedal opening angle is fixed if there is an accelerator pedal malfunction or history of a malfunction. | Pass condition detected and then engine switch turned off |
| P052400 | Oil pressure sender gauge assembly | Engine speed is limited due to fuel cut and throttle restriction (4000 rpm or less). | Pass condition detected |
| P056014 | ECM +B circuit | Generator command is controlled. | Pass condition detected and then engine switch turned off |
| P212012
P212014 P21201C P21201F P212099 P212512 P212514 P21251F P21382B |
Accelerator pedal position sensor | The accelerator pedal position sensor has 2 sensor circuits: Main and Sub.
If either circuit malfunctions, the ECM limits the engine output. If both circuits malfunction, the ECM regards the accelerator pedal as being released. As a result, the throttle valve is closed and the engine idles. |
Pass condition detected and then engine switch turned off |
| P21CF13
P21D013 P21D113 P21D213 |
Port fuel injector assembly | The ECM performs fuel-cut when the engine speed is 2000 rpm or more. | Pass condition detected and then engine switch turned off |
| P223711
P223712 P223714 P223716 P223717 P22371A P225111 P225112 |
Air fuel ratio sensor | Air fuel ratio sensor air fuel ratio feedback control is stopped. | Pass condition detected and then engine switch turned off |
*: The vehicle can be driven slowly if the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.