Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL SOLENOID › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351511 CAMSHAFT OIL CONTROL SOLENOID A

6AR-FSE ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID  INSTALLATION  


PROCEDURE

Hide 15370 1.INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

a.
A413311C01
0.5,0.552 0.677,0.552 0.677,0.552 0.927,0.958 false 0.333,0.469 0.646,0.625 0.313,0.156 10 false *1
*1 O-ring


Apply engine oil to a new O-ring and install it to the camshaft timing oil control solenoid assembly as shown in the illustration.

NOTICE:

Do not damage the O-ring.



b.
A192239C95
1.49,1.938 1.781,1.938 1.781,1.938 1.865,1.583 false 1.323,1.844 1.635,2 0.313,0.156 10 false *a
*a Adhesive 1324


Apply adhesive to 2 or 3 threads of 2 new bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



c.

Install the camshaft timing oil control solenoid assembly to the timing chain cover sub-assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft timing oil control solenoid assembly has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft timing oil control solenoid assembly.




d.

Connect the camshaft timing oil control solenoid assembly connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK