Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351517 CRANKSHAFT POSITION SENSOR A

6AR-FSE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11301K 1.INSTALL CRANKSHAFT POSITION SENSOR

a.

Clean and degrease the threads of the bolt for the crankshaft position sensor.


b.

Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

NOTICE:

If reusing the crankshaft position sensor, be sure to inspect the O-ring.



c.
A192239C95
1.49,1.938 1.781,1.938 1.781,1.938 1.865,1.583 false 1.323,1.844 1.635,2 0.313,0.156 10 false *a
*a Adhesive 1324


Apply adhesive to 2 or 3 threads of the bolt.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.



d.

Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)

NOTICE:
·

If the crankshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.




e.

Connect the crankshaft position sensor connector.


Hide 2.INSPECT FOR ENGINE OIL LEAK