Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › KNOCK SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351521 KNOCK SENSOR A

6AR-FSE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>6AR-FSE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.
A338028C01
1.698,1.906 2.01,2.063 0.313,0.156 10 false *a 2.552,2.594 2.865,2.75 0.313,0.156 10 false *b 0.906,2.521 1.219,2.677 0.313,0.156 10 false *c 0.906,2.677 1.219,2.833 0.313,0.156 10 false *d
*a Top
*b Engine Front
*c 7°
*d 10°


Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

If the knock control sensor has been struck or dropped, replace it.



b.

Connect the knock control sensor connector.


Hide 2.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>6AR-FSE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION