Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351522 AIR FUEL RATIO SENSOR G

6AR-FSE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSPECTION  


PROCEDURE

Hide 89467B 1.INSPECT AIR FUEL RATIO SENSOR

a.
A183494C22
1.979,1.146 2.292,0.854 2.292,0.854 2.5,0.854 false 1.417,1.146 1.135,0.854 1.135,0.854 0.938,0.854 false 1.427,1.625 1.115,1.865 1.115,1.865 0.948,1.865 false 0.146,0.115 0.417,0.333 0.271,0.219 10 false *a 2.563,0.781 3.073,0.979 0.51,0.198 10 false HA1A 0.708,0.771 0.948,0.99 0.24,0.219 10 false +B 0.583,1.76 0.99,1.958 0.406,0.198 10 false A1A-
*a Component without harness connected
(Air Fuel Ratio Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (HA1A) - 2 (+B) 20°C (68°F) 1.6 to 3.2 Ω
1 (HA1A) - 4 (A1A-) Always 10 kΩ or higher


If the result is not as specified, replace the air fuel ratio sensor.