Home › Engine / Hybrid System › 6AR-FSE (ENGINE CONTROL) › HEATED OXYGEN SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072203 6AR-FSE ENGINE CONTROL _0351523 HEATED OXYGEN SENSOR A

6AR-FSE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 89465 1.REMOVE HEATED OXYGEN SENSOR

a.
A413362

Disconnect the heated oxygen sensor connector.


b.
A413363N01
1.719,1.167 2.01,1.167 2.01,1.167 2.26,0.844 true 1.344,1.073 1.698,1.271 0.354,0.198 10 true SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly (TWC: Rear Catalyst).

SST
09224-00012  

NOTICE:

If the heated oxygen sensor has been struck or dropped, replace it.