Home › General › MAINTENANCE › 6AR-FSE BATTERY › 2018.04–2021.02
RM33A0E _V1 General _065356 MAINTENANCE _0351560 6AR-FSE BATTERY A

MAINTENANCE  6AR-FSE BATTERY  INSTALLATION  


PROCEDURE

Hide 1.INSTALL BATTERY

a.

Install the battery to the vehicle.


b.
A427399C01
0,0 0,0 false
V113147

Install in this Direction


Install the No. 2 battery clamp with the bolt to the battery clamp sub-assembly.

Torque:
18.5 N*m (189 kgf*cm, 14 ft.*lbf)


c.

Connect the cable to the positive (+) battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


d.

Engage the 2 claws to install the battery terminal cap to the positive (+) battery terminal.


Hide 2.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

a.

Connect the cable to the negative (-) battery terminal and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION