Home › Engine / Hybrid System › 6AR-FSE (LUBRICATION) › OIL PRESSURE SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072208 6AR-FSE LUBRICATION _0351650 OIL PRESSURE SENSOR A

6AR-FSE LUBRICATION  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 83520 1.INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

a.
A304094C18
1.469,0.354 1.927,0.698 true 1.802,1.25 2.063,1.438 2.063,1.438 2.292,1.438 true 1.25,0.24 1.563,0.396 0.313,0.156 10 false *a 2.323,1.323 2.635,1.521 0.313,0.198 10 false *b
*a Adhesive
*b Oil Inlet Port


Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent


NOTICE:
·

Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

·

Install the oil pressure sender gauge assembly within 3 minutes of applying adhesive.




b.

Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

Torque:
15 N*m (153 kgf*cm, 11 ft.*lbf)

NOTICE:

Do not start the engine within 1 hour of installation.



c.

Connect the oil pressure sender gauge assembly connector.