Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _065373 AUDIO / VIDEO _0351788 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  USB Audio System Recognition/Play Error  


DESCRIPTION

When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by the radio receiver assembly. This diagnostic procedure is for when a device is not recognized, or files from the device cannot be played normally.

WIRING DIAGRAM

E372236E02
0.979,0.604 1.438,0.802 0.458,0.198 10 false UPI 0.865,1.188 1.323,1.385 0.458,0.198 10 false UDO- 0.854,1.792 1.313,1.99 0.458,0.198 10 false UDO+ 0.854,2.448 1.313,2.646 0.458,0.198 10 false UJSG 0.854,3.052 1.313,3.25 0.458,0.198 10 false UJSS 3.292,2.854 4.094,3.125 0.802,0.271 10 false (Shielded) 1.875,4.177 5.344,4.427 3.469,0.25 10 false : Data Signal (USB Communication Line) 5.948,0.604 6.563,0.802 0.615,0.198 10 false USV1 5.958,1.198 6.573,1.396 0.615,0.198 10 false US1- 5.958,1.802 6.573,2 0.615,0.198 10 false US1+ 5.938,2.458 6.552,2.656 0.615,0.198 10 false UGD1 5.938,3.094 6.552,3.292 0.615,0.198 10 false USG1 1.375,0.5 1.552,0.75 0.177,0.25 10 false 8 1.385,1.052 1.563,1.302 0.177,0.25 10 false 9 1.365,1.667 1.542,1.917 0.177,0.25 10 false 10 1.365,2.333 1.542,2.583 0.177,0.25 10 false 11 1.344,2.927 1.521,3.177 0.177,0.25 10 false 12 5.698,0.5 5.875,0.75 0.177,0.25 10 false 1 5.698,1.042 5.875,1.292 0.177,0.25 10 false 2 5.708,1.677 5.885,1.927 0.177,0.25 10 false 3 5.708,2.333 5.885,2.583 0.177,0.25 10 false 4 5.677,2.927 5.854,3.177 0.177,0.25 10 false 5 0.313,3.469 0.927,3.667 0.615,0.198 10 false K5 0.313,3.656 2.646,3.979 2.333,0.323 10 false No. 1 Stereo Jack Adapter Assembly 5.354,3.625 7.031,4.135 1.677,0.51 10 false Radio Receiver Assembly 5.354,3.438 5.969,3.635 0.615,0.198 10 false K153

CAUTION / NOTICE / HINT

HINT:
·

When a large amount of data is in a USB device, it may take a while to begin playback.

·

When using a USB device, files that are copy protected or encrypted due to copyright reasons cannot be played.

·

When files are not played in the sorted order, perform the following procedure before inspection.

(a)

Add numbers in front of the file names.

(b)

Put the files in a folder and copy the folder data to the USB device.




PROCEDURE

1.CHECK USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Check if playable files are present on the USB device or "iPod".

HINT:

Refer to System Description for playable files.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)>SYSTEM DESCRIPTION



c.

Check if the USB device is a compatible format or "iPod" is a compatible version.

HINT:

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)>SYSTEM DESCRIPTION


Result:
Result Proceed to
No playable files exist, or incompatible device format or version A
Playable files exist, and compatible device format or version B




A

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR NO PLAYABLE FILES PRESENT

B

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.
E360495C47
1.521,2.24 1.865,2.479 0.344,0.24 1.542,0.198 1.958,0.469 0.417,0.271 2.167,1.958 1.76,1.51 false 1.833,1.188 2.292,1.219 false 1.833,1.354 2.292,1.5 false 1.052,1.406 1.573,1.167 false 1.031,1.75 1.552,1.375 false 1.906,3.656 2.396,3.771 false 1.417,4.083 1.656,3.76 false 0.958,4.063 1.635,3.667 false 0.906,3.708 1.521,3.656 false 2.135,4 1.792,3.656 false 0.229,0.229 0.542,0.427 0.313,0.198 10 false *a 0.24,2.802 0.552,3 0.313,0.198 10 false *b 0.688,1.385 1.135,1.563 0.448,0.177 10 false UGD1 0.698,1.729 1.125,1.938 0.427,0.208 10 false US1+ 2.198,1.927 2.688,2.167 0.49,0.24 10 false USG1 2.313,1.438 2.729,1.688 0.417,0.25 10 false US1- 0.646,3.635 0.958,3.833 0.313,0.198 10 false UPI 0.635,4.021 1.031,4.281 0.396,0.26 10 false UDO- 1.24,4.094 1.74,4.354 0.5,0.26 10 false UJSS 2.156,4 2.594,4.26 0.438,0.26 10 false UDO+ 2.427,3.708 2.927,3.948 0.5,0.24 10 false UJSG 1.594,0.26 2.031,0.469 0.438,0.208 10 false K153 1.604,2.281 1.917,2.479 0.313,0.198 10 false K5 2.313,1.146 2.74,1.375 0.427,0.229 10 false USV1
*a Front view of wire harness connector
(to Radio Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Disconnect the K153 radio receiver assembly connector.


b.

Disconnect the K5 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K5-8 (UPI) - K153-1 (USV1) Always Below 1 Ω
K5-9 (UDO-) - K153-2 (US1-) Always Below 1 Ω
K5-10 (UDO+) - K153-3 (US1+) Always Below 1 Ω
K5-11 (UJSG) - K153-4 (UGD1) Always Below 1 Ω
K5-12 (UJSS) - K153-5 (USG1) Always Below 1 Ω
K5-8 (UPI) or K153-1 (USV1) - Body ground Always 10 kΩ or higher
K5-9 (UDO-) or K153-2 (US1-) - Body ground Always 10 kΩ or higher
K5-10 (UDO+) or K153-3 (US1+) - Body ground Always 10 kΩ or higher
K5-11 (UJSG) or K153-4 (UGD1) - Body ground Always 10 kΩ or higher
K5-12 (UJSS) or K153-5 (USG1) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT RADIO RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT RADIO RECEIVER ASSEMBLY (NO. 1 STEREO JACK ADAPTER ASSEMBLY POWER SOURCE)
a.

Reconnect the K153 radio receiver assembly connector.


b.
E360496C22
1.573,0.594 1.938,0.844 0.365,0.25 1.99,2.5 2.844,2.052 false 1.438,2.51 0.802,2.365 false 0.167,0.167 0.479,0.365 0.313,0.198 10 false *a 1.667,0.635 1.979,0.833 0.313,0.198 10 false K5 0.552,2.281 0.958,2.531 0.406,0.25 10 false UPI 2.885,1.948 3.396,2.156 0.51,0.208 10 false UJSG
*a Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
K5-8 (UPI) - K5-11 (UJSG) Engine switch on (ACC) 5 V



Result:
Proceed to
OK
NG



OK

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK

NG

REPLACE RADIO RECEIVER ASSEMBLY

4.FORMAT USB DEVICE OR RESTORE "iPod" AND RECHECK
a.

Delete all files in the USB device or "iPod" and format/restore it.


b.

Save the data again and check if it can be played on the in-vehicle device.

NOTICE:

Formatting a USB device or restoring an "iPod" erases all music on the device.

Ensure that backup music data is available before performing this operation.


OK:

Malfunction disappears.



Result:
Proceed to
OK
NG



OK

END

NG

5.REPLACE USB DEVICE OR "iPod"
5.REPLACE USB DEVICE OR "iPod"
a.

Turn the engine switch off.

HINT:

When this malfunction occurs, it is necessary to turn the engine switch off to make it possible for the vehicle to recognize a new device when it is connected.



b.

Turn the engine switch on (ACC).


c.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.


HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

·

Refer to System Description for compatible formats and versions.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)>SYSTEM DESCRIPTION



Result:
Proceed to
NEXT



NEXT

6.CHECK USB DEVICE OR "iPod"
6.CHECK USB DEVICE OR "iPod"
a.

Check if a USB device or "iPod" is recognized by the radio receiver assembly, and if information such as track, artist and album names are displayed on the screen.

OK:

USB device or "iPod" is recognized properly and the information is displayed on the screen.



Result:
Proceed to
OK
NG



OK

USB DEVICE OR "iPod" WAS INCOMPATIBLE OR DEFECTIVE

NG