Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) › 2018.04–2021.02
RM33A0E _56 Audio / Visual / Telematics _065373 AUDIO / VIDEO _0351788 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Radio Receiver Power Source Circuit  


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E315454E03
1.115,0.771 2.219,1.531 1.104,0.76 10 false from Battery 0.5,1.948 2.25,2.875 1.75,0.927 10 false from ACC NO. 1 Relay 5.302,4.885 7.021,5.375 1.719,0.49 10 false Radio Receiver Assembly 6.052,0.781 6.51,0.979 0.458,0.198 10 false +B1 3.719,0.938 4.49,1.135 0.771,0.198 10 false RADIO 5.292,4.688 5.823,4.917 0.531,0.229 10 false K152 6.052,1.969 6.667,2.167 0.615,0.198 10 false ACC1 6.052,3.219 6.667,3.417 0.615,0.198 10 false GND1 5.833,0.677 5.99,0.875 0.156,0.198 10 false 4 5.833,1.875 5.99,2.073 0.156,0.198 10 false 3 5.833,3.094 5.99,3.292 0.156,0.198 10 false 7 3.604,2.135 4.677,2.333 1.073,0.198 10 false ECU-ACC

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)
a.

Disconnect the K152 radio receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K152-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
K152-4 (+B1) - K152-7 (GND1) Always 11 to 14 V
K152-3 (ACC1) - K152-7 (GND1) Engine switch on (ACC) 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR