Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › REAR SEAT SIDE AIRBAG ASSEMBLY (for Reclining Seat Type) › 2018.04–2021.02
RM33A0E _58 Vehicle Interior _065383 SUPPLEMENTAL RESTRAINT SYSTEMS _0352092 REAR SEAT SIDE AIRBAG ASSEMBLY(for Reclining Seat Type) A

SUPPLEMENTAL RESTRAINT SYSTEMS  REAR SEAT SIDE AIRBAG ASSEMBLY(for Reclining Seat Type)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 73940A 1.INSTALL REAR SEAT AIRBAG ASSEMBLY

a.

Install the rear seat airbag assembly with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

NOTICE:
·

Do not reuse the nuts.

·

Make sure that the rear side seatback frame sub-assembly is not deformed. If it is deformed, replace the rear side seatback frame sub-assembly with a new one.




b.

Connect the wire harness to the wire harness clamp.


c.

Engage the clamp.


Hide 2.INSTALL REAR SIDE SEATBACK COVER WITH PAD

Hide 62332A 4.CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

Hide 71940A 7.INSTALL REAR SEAT HEADREST ASSEMBLY

Hide 72693 8.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 73350C 10.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

for 2AR-FE: Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>INSTALLATION

for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION