Home › Engine / Hybrid System › 6AR-FSE (FUEL) › FUEL PRESSURE SENSOR › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072204 6AR-FSE FUEL _0353737 FUEL PRESSURE SENSOR A

6AR-FSE FUEL  FUEL PRESSURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure sensor (fuel delivery pipe sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
·

Replacement of fuel pressure sensor (fuel delivery pipe sub-assembly)

·

Replacement of direct fuel injector assembly

·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Gas leak from exhaust system is repaired


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
·
A360563

Never perform work on fuel system components near any possible ignition sources.

·

Vaporized fuel could ignite, resulting in a serious accident.


·
A360564

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

·

Sparks could cause vaporized fuel to ignite, resulting in a serious accident.



PROCEDURE

Hide 23807 1.REMOVE FUEL PRESSURE SENSOR (FUEL DELIVERY PIPE SUB-ASSEMBLY)

Click hereEngine / Hybrid System>6AR-FSE (FUEL)>FUEL INJECTOR (for Direct Injection)>REMOVAL

NOTICE:
·

Do not remove the fuel pressure sensor from the fuel delivery pipe sub-assembly.

·

If the fuel pressure sensor is removed, replace the fuel pressure sensor (fuel delivery pipe sub-assembly) with a new one.