Home › Engine / Hybrid System › 6AR-FSE (FUEL) › FUEL PUMP ECU › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072204 6AR-FSE FUEL _0353740 FUEL PUMP ECU A

6AR-FSE FUEL  FUEL PUMP ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control) (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B422343

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If an airbag deploys for any reason, it may cause a serious injury.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 73350C 3.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 72693 5.REMOVE REAR SEAT CUSHION LOCK HOOK

Hide 62332A 7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

Hide 8.REMOVE REAR SIDE SEATBACK ASSEMBLY LH

Hide 62331A 9.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 10.REMOVE REAR SIDE SEATBACK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 81006 11.REMOVE CENTER STOP LIGHT SET

Hide 73370E 12.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

Hide 73360D 13.DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 62472A 14.REMOVE INNER ROOF SIDE GARNISH LH

Hide 62471A 15.REMOVE INNER ROOF SIDE GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 73373F 16.REMOVE REAR SEAT SHOULDER BELT HOLE COVER

Hide 64330 17.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

Hide 64272B 18.REMOVE ROOM PARTITION BOARD LH

Hide 89570A 19.REMOVE FUEL PUMP CONTROL ECU ASSEMBLY

a.
A420656

Disconnect the fuel pump control ECU assembly connector.


b.
A420657

Remove the nut and fuel pump control ECU assembly from the vehicle body.

NOTICE:

Do not reuse the fuel pump control ECU assembly if it has been dropped or subjected to a severe impact.