The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel tank assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
2.DRAIN FUEL
17420
3.REMOVE CENTER EXHAUST PIPE ASSEMBLY
77641A
4.REMOVE NO. 1 FUEL TANK PROTECTOR
| *a | Needle Nose Pliers |
Using needle nose pliers, remove the 4 clips and No. 1 fuel tank protector from the fuel tank assembly.
77754B
5.DISCONNECT CHARCOAL CANISTER OUTLET HOSE
Disconnect the charcoal canister outlet hose from the fuel tank filler pipe sub-assembly.
6.DISCONNECT FUEL TANK BREATHER TUBE SUB-ASSEMBLY
Loosen the clamp, then disconnect the fuel tank breather tube sub-assembly from the fuel tank filler pipe sub-assembly.
77213E
7.DISCONNECT FUEL TANK TO FILLER PIPE HOSE
Loosen the clamp, then disconnect the fuel tank to filler pipe hose from the fuel tank assembly.
77026A
8.DISCONNECT NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Slide the clip and disconnect the No. 1 fuel evaporation tube sub-assembly from the fuel pipe.
77209F
9.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
| *A | for Type A |
| *B | for Type B |
Disconnect the fuel tank main tube sub-assembly from the fuel pipe.
Click hereEngine / Hybrid System>6AR-FSE (FUEL)>FUEL SYSTEM>PRECAUTION
77100
10.REMOVE FUEL TANK ASSEMBLY
The fuel tank assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the fuel tank assembly may fall off the engine lifter.
Support the fuel tank assembly using an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Remove the 4 bolts, No. 1 fuel tank band sub-assembly LH and No. 1 fuel tank band sub-assembly RH.
Lower the engine lifter to remove the fuel tank assembly.
Be careful not to drop the fuel tank assembly.
When removing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
77209F
11.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY
| *A | for Type A |
| *B | for Type B |
Disengage the clamp to remove the fuel tank main tube sub-assembly from the fuel tank assembly.
77289B
12.REMOVE NO. 3 FUEL TUBE CLAMP
Disengage the clamp to remove the No. 3 fuel tube clamp from the fuel tank assembly.
77754B
13.REMOVE CHARCOAL CANISTER OUTLET HOSE
Disengage the clamp to remove the charcoal canister outlet hose from the fuel tank assembly.
77026A
14.REMOVE NO. 1 FUEL EVAPORATION TUBE SUB-ASSEMBLY
Disengage the clamp to remove the No. 1 fuel evaporation tube sub-assembly from the fuel tank assembly.
77656B
15.REMOVE NO. 6 FUEL TANK CUSHION
Remove the No. 6 fuel tank cushion from the fuel tank assembly.
77652A
16.REMOVE NO. 2 FUEL TANK CUSHION
Remove the 2 No. 2 fuel tank cushions from the fuel tank assembly.