The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel sender gauge assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
77020A
1.REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
83320
2.REMOVE FUEL SENDER GAUGE ASSEMBLY
|
Fuel Sender Gauge Assembly Connector |
|
Harness Protector |
Disconnect the fuel sender gauge assembly connector.
Remove the harness protector from the wire harness.
Disengage the 2 clamps to disconnect the wire harness from the fuel suction plate sub-assembly.
Do not damage the wire harness.
Disengage the claw to remove the fuel sender gauge assembly from the fuel suction tube with pump and gauge assembly.
Be careful not to bend the arm of the fuel sender gauge assembly.