Home › Engine / Hybrid System › 6AR-FSE (EMISSION CONTROL) › PURGE VALVE › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072205 6AR-FSE EMISSION CONTROL _0353750 PURGE VALVE A

6AR-FSE EMISSION CONTROL  PURGE VALVE  INSTALLATION  


PROCEDURE

Hide 25860 1.INSTALL PURGE VALVE (PURGE VSV)

a.
A413902C01
1.75,2.708 1.958,2.813 1.958,2.813 2.156,2.813 true 1.281,2.083 0.844,2.083 true 1.083,0.833 1.167,1.063 1.167,1.063 1.417,1.063 true 0.531,3.635 0.781,3.635 0.781,3.635 1.094,3.813 true 2.188,2.76 2.385,2.927 0.198,0.167 10 true *1 0.667,2.01 0.844,2.188 0.177,0.177 10 true *2 0.49,0.625 0.75,0.813 0.26,0.188 10 false *a 1.156,3.219 1.469,3.375 0.313,0.156 10 false *b 1.01,1.344 1.219,1.531 0.208,0.188 10 false *c 1.115,1.198 1.313,1.396 0.198,0.198 10 false *d 2.635,4.281 2.875,4.458 0.24,0.177 10 false *e 2.656,1.292 2.854,1.479 0.198,0.188 10 false *f 1.427,0.958 1.615,1.167 0.188,0.208 10 false *g 0.375,3.531 0.563,3.74 0.188,0.208 10 false *g 0.458,3.75 0.719,3.938 0.26,0.188 10 false *a
*1 Fuel Vapor Hose
*2 Fuel Vapor Feed Hose Assembly
*a Left
*b Front
*c Rear
*d 60°
*e 4 to 9 mm (0.157 to 0.354 in.)
*f 2 to 7 mm (0.0787 to 0.276 in.)
*g Paint Mark


Install the purge valve (purge VSV) to the intake manifold with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the purge valve (purge VSV) connector.


c.

Connect the fuel vapor feed hose assembly to the purge valve (purge VSV) and slide the clip to secure it.

HINT:

Make sure the direction of the clip is as shown in the illustration.



d.

Connect the fuel vapor hose to the purge valve (purge VSV) and slide the clip to secure it.

HINT:

Make sure the direction of the clip is as shown in the illustration.