Home › Engine / Hybrid System › 6AR-FSE (EMISSION CONTROL) › PURGE VALVE › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072205 6AR-FSE EMISSION CONTROL _0353750 PURGE VALVE G

6AR-FSE EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VALVE (PURGE VSV)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge valve (purge VSV).


b.
A340933C01
0.281,0.385 0.458,0.385 0.458,0.385 0.677,0.833 false 0.865,2 1.042,2 1.042,2 1.479,1.125 false 0.635,1.896 1.031,2.146 0.396,0.25 10 false *a 0.063,0.302 0.438,0.583 0.375,0.281 10 false *b 2.167,1.938 2.5,2.135 0.333,0.198 10 false *c
*a Port (E)
*b Port (F)
*c Air


Apply battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).

OK:
Measurement Condition Specified Condition
Battery voltage applied between terminals 1 and 2 Air flows from port (F)
Battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the purge valve (purge VSV).