RM33A0E
_V1
General
_065355
SPECIFICATIONS
_0356477
6AR-FSE FUEL
F
SPECIFICATIONS 6AR-FSE FUEL SERVICE DATA
| Fuel pressure
|
Standard fuel pressure
|
196 to 588 kPa (2.0 to 6.0 kgf/cm2, 28 to 85 psi)
|
| Standard fuel pressure (for high pressure)
|
2000 to 20000 kPa at 3000 rpm (shift lever in P, engine warmed up, A/C off and injection mode direct)
|
| Fuel pressure: for 5 minutes after engine has stopped
|
Standard fuel pressure
|
147 kPa (1.5 kgf/cm2, 21 psi)
|
| Port fuel injector assembly
|
Standard resistance
|
11.6 to 12.4 Ω at 20°C (68°F)
|
| Standard injection volume
|
54 to 65 cc (3.3 to 4.0 cu. in.) per 15 seconds
|
| Difference between each fuel injector assembly
|
11 cc (0.7 cu. in.) or less
|
| Standard fuel drop
|
1 drop or less per 23 minutes
|
| Direct fuel injector assembly
|
Standard resistance
|
1.74 to 2.04 Ω at 20°C (68°F)
|
| Fuel pressure sensor
|
Standard voltage
|
3 (PR) - 2 (E2)
|
Approximately 0.4 to 0.6 V
|
| Fuel pump with filter assembly
|
Standard resistance
|
0.2 to 3.0 Ω at 20°C (68°F)
|
| Fuel pump with seal sub-assembly
|
Standard resistance
|
0.5 Ω at 20°C (68°F)
|
| Fuel sender gauge assembly
|
Standard voltage
|
4.255 to 4.605 V (Float level F)
|
| 0.345 to 4.605 V (Float level F to E)
|
| 0.345 to 0.695 V (Float level E)
|