Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR BELT MOULDING › 2018.04–2021.02
RM33A0E _59 Vehicle Exterior _065397 EXTERIOR PANELS / TRIM _0319667 REAR DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR BELT MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door belt moulding removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic View Monitor System (Click here)
·

Rear door glass sub-assembly

·

Rear door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Catch protection function

·

Window open warning function


(Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 74038B 3.REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY

Hide 4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

Hide 74260 5.REMOVE REAR ARMREST ASSEMBLY

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 68174A 7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67844A 8.REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER

Hide 67842E 9.REMOVE REAR DOOR SERVICE HOLE COVER

Hide 67848A 10.REMOVE REAR DOOR NO. 1 VENT SEAL

Hide 67858B 11.REMOVE REAR DOOR PANEL PROTECTOR

Hide 68152C 12.REMOVE REAR DOOR GLASS RUN

Hide 67872 13.DISCONNECT REAR DOOR WEATHERSTRIP

Hide 67408F 14.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68124B 15.REMOVE REAR DOOR QUARTER WINDOW GLASS

Hide 68104 16.REMOVE REAR DOOR GLASS SUB-ASSEMBLY

Hide 75740 17.REMOVE REAR DOOR BELT MOULDING ASSEMBLY

a.
B469798C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the rear door belt moulding assembly as shown in the illustration.


b.
B469799C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Disengage the 5 claws and guide to remove the rear door belt moulding assembly as shown in the illustration.