The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during stereo component amplifier assembly removal/installation are shown below.
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1.REMOVE FRONT SEAT ASSEMBLY LH
86183E
2.REMOVE AUDIO AMPLIFIER COVER
Remove the 3 clips and audio amplifier cover.
3.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET
Disconnect each connector.
Disengage the clamp.
Turn back the front floor carpet assembly and front floor mat as shown in the illustration.
Remove the bolt.
Disengage the 2 guides and remove the stereo component amplifier assembly with bracket as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
86285
4.REMOVE NO. 1 AMPLIFIER BRACKET
Remove the 2 screws and No. 1 amplifier bracket.
86286
5.REMOVE NO. 2 AMPLIFIER BRACKET
Remove the 2 screws and No. 2 amplifier bracket.
86280
6.REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY