Home › Engine / Hybrid System › 2AR-FE (COOLING) › THERMOSTAT › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _065328 2AR-FE COOLING _0319475 THERMOSTAT A

2AR-FE COOLING  THERMOSTAT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during thermostat removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 27020 2.REMOVE GENERATOR ASSEMBLY

Hide 16572D 3.DISCONNECT NO. 2 RADIATOR HOSE

Hide 16321 4.REMOVE WATER INLET

a.
A406821

Remove the 2 nuts and water inlet.


Hide 16331A 5.REMOVE THERMOSTAT

a.

Remove the thermostat from the water inlet housing.


b.

Remove the gasket from the thermostat.