1.DRAIN ENGINE COOLANT
11209
2.REMOVE V-BANK COVER SUB-ASSEMBLY
12327A
3.REMOVE NO. 2 ENGINE MOUNTING STAY RH
16470
4.SEPARATE RADIATOR RESERVE TANK ASSEMBLY
Disengage the clamp.
Remove the bolt, nut to separate the radiator reserve tank assembly.
12305
5.REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
Disengage the 2 clamps.
Remove the bolt to separate the suction hose sub-assembly, suction pipe sub-assembly and air conditioning tube and accessory assembly.
Remove the bolt to disconnect the No. 1 bond cable from the engine mounting insulator sub-assembly RH.
Using a safety stand, support the engine assembly with transaxle at the position shown in the illustration.
|
Support Area | - | - |
Make sure to firmly support the weight of the engine assembly and automatic transaxle assembly before removing the engine mounting insulator sub-assembly RH.
Do not place the safety stand under the oil pan.
|
Support Area |
Support the engine assembly with automatic transaxle assembly at the position shown in the illustration to stabilize it.
Remove the 3 bolts and nut to separate the engine mounting insulator sub-assembly RH from the front No. 1 engine mounting bracket LH.
Remove the nut, 2 bolts and engine mounting insulator sub-assembly RH from the engine mounting spacer and vehicle body.
82121
6.DISCONNECT ENGINE WIRE
Disconnect the water inlet with thermostat sub-assembly connector.
Remove the bolt.
Disengage the clamp to disconnect the engine wire.
12315
7.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH
16261
8.DISCONNECT WATER BY-PASS HOSE
Slide the clip and disconnect the water by-pass hose.
16031
9.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Remove the 2 bolts, 2 nuts and water inlet with thermostat sub-assembly.
Remove the gasket from the water inlet with thermostat sub-assembly.