41311
1.INSPECT FRONT DIFFERENTIAL CASE
Using SST, rotate the front differential side gear as shown in the illustration.
The front differential side gear does not lock when rotated in either direction.
If the front differential side gear locks, perform all of the following inspections.
If the front differential side gear still locks after replacing the malfunctioning parts, replace the front differential case.
2.INSPECT FRONT DIFFERENTIAL PINION BACKLASH
Install SST as shown in the illustration and tighten it.
| *a | Turn | *b | Hold |
Secure the front differential case in a vise between aluminum plates.
Do not overtighten the vise.
| *1 | Front No. 1 Differential Pinion Shaft |
Install the front No. 1 differential pinion shaft to the front differential pinion as shown in the illustration.
Using a dial indicator, measure the front differential pinion backlash.
0.20 mm (0.00787 in.) or less
If the backlash is not as specified, replace the front No. 1 differential side gear thrust washers with washers of a different thickness. Use the table below to select a front No. 1 differential side gear thrust washer which will ensure that the backlash is within the specification.
Select front No. 1 differential side gear thrust washers of the same thickness for both the right and left side.
| Part No. | Thickness [mm (in.)] |
|---|---|
| 41361-33340 | 0.90 (0.0354) |
| 41361-33350 | 0.95 (0.0374) |
| 41361-33360 | 1.00 (0.0394) |
| 41361-33370 | 1.05 (0.0413) |
| 41361-33380 | 1.10 (0.0433) |
| 41361-33390 | 1.15 (0.0453) |
| 41361-33400 | 1.20 (0.0472) |
| 41361-33410 | 1.25 (0.0492) |
41351F
3.INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER
Using a micrometer, measure the thickness of the front differential pinion thrust washer.
0.90 mm (0.0354 in.)
Measure the most worn portion of the front differential pinion thrust washer.
If the thickness is less than the minimum, replace the front differential pinion thrust washer.
41342F
4.INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT
Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.
17.975 mm (0.708 in.)
Measure the most worn portion of the front No. 1 differential pinion shaft.
If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.