The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump assembly removal/installation are shown below.
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. DISCHARGE FUEL SYSTEM PRESSURE
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
17111
4.REMOVE INTAKE MANIFOLD
23214A
5.REMOVE FUEL PUMP PROTECTOR
Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel pump protector.
Remove the 2 bolts and fuel pump protector from the cylinder head sub-assembly.
6.DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
Disconnect the No. 2 fuel tube sub-assembly from the fuel pump assembly.
Click hereEngine / Hybrid System>2GR-FKS (FUEL)>FUEL SYSTEM>PRECAUTION
23801P
7.REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
Loosen the 2 bolts of the fuel pump assembly.
Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe RH and fuel pump assembly.
23100X
8.REMOVE FUEL PUMP ASSEMBLY
Disconnect the fuel pump assembly connector.
Remove the 2 bolts, fuel pump assembly and fuel pump lifter guide from the cylinder head cover sub-assembly.
Remove the O-ring from the fuel pump assembly.
Remove the fuel pump lifter assembly from the fuel pump lifter housing.
Remove the fuel pump spacer gasket from the cylinder head cover sub-assembly.