84922A
1.INSPECT FRONT LUMBAR POWER SEAT SWITCH (DRIVER SEAT)
| *a | Front Lumbar Power Seat (Release) |
| *b | Front Lumbar Power Seat (Hold) |
| *c | Component without harness connected
(Front Lumbar Power Seat Switch (Driver Seat)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 - 5 | Front lumbar power seat (Hold) pressed | Below 1 Ω |
| 4 - 3 | ||
| 4 - 5 | Off | |
| 4 - 3 | ||
| 4 - 5 | Front lumbar power seat (Release) pressed | |
| 2 - 3 |
If the result is not as specified, replace the front lumbar power seat switch (driver seat).