1.SECURE VEHICLE
Fully apply the parking brake and chock a wheel.
Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.
2.REMOVE CONSOLE BOX ASSEMBLY
3.ADJUST SHIFT LEVER POSITION
Before adjusting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.
Disconnect the transmission control cable assembly from the transmission floor shift assembly.
| *a | Counterclockwise |
Rotate the lock nut counterclockwise approximately 180° and, while holding the lock nut in that position, disconnect the transmission control cable assembly from the transmission floor shift assembly.
| *a | Adjuster Case Cover |
| *b | Slide |
Slide the adjuster case cover in the direction shown by the arrow.
| *a | Lock Piece |
| *b | Pull Out |
| *c | Adjuster Case |
Using a precision screwdriver, pull out the lock piece of the adjuster case.
| *a | Lock Nut |
| *b | Push in |
| *c | Stopper |
Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.
| *a | Stopper |
Connect the transmission control cable assembly to the transmission floor shift assembly.
After installation, check that the outer part of the stopper is as shown in the illustration.
Connect the transmission control cable assembly to the transmission floor shift assembly.
Before connecting the transmission control cable assembly, check that the shift lever is in N.
Securely connect the end of the transmission control cable assembly to the transmission floor shift assembly.
| *a | Lock Piece |
| *b | Push in |
| *c | Adjuster Case |
Push in the lock piece of the adjuster case to lock it.
| *a | Lock Piece |
| *b | Adjuster Case Cover |
Move the adjuster case cover in the direction shown by the arrow.
If the adjuster case cover is not moved far enough so that the adjuster case cover engages the lock piece, the transmission control cable assembly will not be able to lock, and reliable shift operation will not be possible.
4.INSTALL CONSOLE BOX ASSEMBLY