Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › SPEED SENSOR › 2019.10–2020.02
RM33A0E _52 Drivetrain _065351 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0319432 SPEED SENSOR A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  SPEED SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor (NT) and transmission revolution sensor (NC) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: for TMC Made

Transmission valve body assembly
1.

Reset memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)for Initialization
(Click here)for Registration
Replacement of automatic transaxle fluid*1 ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 35410 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

Hide 89413N 2.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

a.
C361014

Remove the bolt and transmission revolution sensor (NT) from the automatic transaxle case sub-assembly.


Hide 89413S 3.REMOVE TRANSMISSION REVOLUTION SENSOR (NC)

a.
C369213C01
0.823,0.667 1,0.667 false 1.031,0.573 1.25,0.771 0.219,0.198 10 false *1
*1 Spacer


Remove the bolt, spacer and transmission revolution sensor (NC) from the counter drive gear sub-assembly.