Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
75732A
1.INSTALL FRONT DOOR OUTSIDE MOULDING
When installing the front door outside moulding, heat the vehicle body using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 20 to 30 °C (68 to 86 °F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body excessively.
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove any double-sided tape from the vehicle body.
Wipe off any tape adhesive residue with cleaner.
| *a | Primer |
Using a brush or felt, apply primer or equivalent to the front door outside moulding installation area.
Install the front door outside moulding.
Using a heat light, heat the vehicle body surface.
Align the front door outside moulding as shown in the illustration.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 3 mm (0.118 in.) | B | 3 mm (0.118 in.) |
Remove the release paper from the front door outside moulding.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Double-sided Tape |
Attach the double-sided tape to install the front door outside moulding.
Attach the front door outside moulding in the direction indicated by the arrow shown in the illustration.
Press the front door outside moulding firmly to install it.
Remove the protective tape.