Use the same procedures for the RH side and LH side.
The following procedure is for the LH side.
75742
1.REMOVE REAR DOOR OUTSIDE MOULDING
When removing the rear door outside moulding, heat the vehicle body and rear door outside moulding using a heat light.
| Item | Temperature |
|---|---|
| Rear Door Outside Moulding and Vehicle Body | 40 to 60°C (104 to 140°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the vehicle body and rear door outside moulding excessively.
|
Protective Tape |
Apply protective tape around the rear door outside moulding as shown in the illustration.
Using a heat light, heat the vehicle body and rear door outside moulding.
| *a | Double-sided Tape |
Separate the double-sided tape to remove the rear door outside moulding.