Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR OUTSIDE MOULDING › from 2020.02
RM33A0E _59 Vehicle Exterior _065397 EXTERIOR PANELS / TRIM _0418252 REAR DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR OUTSIDE MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 75742 1.INSTALL REAR DOOR OUTSIDE MOULDING

HINT:

When installing the rear door outside moulding, heat the vehicle body using a heat light.


Heating Temperature:
Item Temperature
Vehicle Body 20 to 30 °C (68 to 86 °F)


CAUTION:
E306500C23
2.365,2 2.698,2 false 0.5,2.333 0.5,2.667 true 0.427,2.708 0.74,2.865 0.313,0.156 10 false *a 2.76,1.927 3.073,2.083 0.313,0.156 10 false *b
*a Heated Part
*b Heat Light


·

Do not touch the heat light and heated parts, touching the heat light may result in burns.

·

Touching heated parts for a long time may result in burns.



NOTICE:

Do not heat the vehicle body excessively.


a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove any double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B571178C01
1.615,1.365 1.615,0.875 true 1.542,1.375 1.854,1.573 0.313,0.198 10 false *a
*a Primer


Using a brush or felt, apply primer or equivalent to the rear door outside moulding installation area.


c.

Install the rear door outside moulding.

i.

Using a heat light, heat the vehicle body surface.


ii.

Align the rear door outside moulding as shown in the illustration.

B571179N01
0.74,2.177 0.896,2.375 0.156,0.198 10 false A 2.417,3.271 2.573,3.469 0.156,0.198 10 false B

Standard Measurement:
Area Measurement Area Measurement
A 3 mm (0.118 in.) B 3 mm (0.118 in.)



iii.

Remove the release paper from the rear door outside moulding.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



iv.
B571180C01
0.677,0.792 0.917,1.375 0.917,1.375 1.167,0.917 true 2.479,1.365 2.479,0.875 true 0.844,1.385 1.156,1.583 0.313,0.198 10 false *a 2.396,1.354 2.708,1.552 0.313,0.198 10 false *a
*a Double-sided Tape


Attach the double-sided tape to install the rear door outside moulding.

HINT:
·

Attach the rear door outside moulding in the direction indicated by the arrow shown in the illustration.

·

Press the rear door outside moulding firmly to install it.





d.

Remove the protective tape.