Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › VALVE BODY ASSEMBLY › from 2020.02
RM33A0E _52 Drivetrain _065351 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0319434 VALVE BODY ASSEMBLY A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  VALVE BODY ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission valve body assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Transmission valve body assembly

·

Solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve


1.

Reset memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)for Initialization
(Click here)for Registration
Replacement of automatic transaxle fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)

PROCEDURE

Hide 35410 2.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

a.
C361011

Disengage the clamp to disconnect the transmission revolution sensor (NC) wire connector.


b.
C361012

Remove the 9 bolts and transmission valve body assembly from the automatic transaxle case sub-assembly.


c.
C361027C01
1.74,0.271 1.948,0.479 0.208,0.208 10 true *1 0.833,1.604 1.01,1.781 0.177,0.177 10 true *3 2.417,1.667 2.583,1.854 0.167,0.188 10 true *1 2.375,1.958 2.552,2.135 0.177,0.177 10 true *1 0.906,1.979 1.083,2.146 0.177,0.167 10 true *2
*1 Transaxle Case Gasket
*2 No. 1 Front Oil Pump Cover Gasket
*3 No. 2 Front Oil Pump Cover Gasket


Remove the 2 transaxle case gaskets from the automatic transaxle case sub-assembly.


d.

Remove the transaxle case gasket from the counter drive gear sub-assembly.


e.

Remove the No. 1 front oil pump cover gasket from the front oil pump assembly.


f.

Remove the No. 2 front oil pump cover gasket from the front oil pump assembly.