| *a | Centering Bolt |
| *b | Standard Bolt |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Centering bolts are used to install the door hinges to the vehicle body and door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.
The specified torque for standard bolts is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
1.INSPECT FRONT DOOR
Check that the clearance measurements of areas a through m are within each standard range.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| a | 3.3 to 6.7 mm (0.130 to 0.264 in.) | b | 3.5 to 7.5 mm (0.138 to 0.295 in.) |
| c | 3.3 to 6.7 mm (0.130 to 0.264 in.) | d | 0.2 to 4.2 mm (0.0079 to 0.165 in.) |
| e | 3.3 to 6.7 mm (0.130 to 0.264 in.) | f | 1.2 to 5.2 mm (0.0472 to 0.205 in.) |
| g | 3.3 to 6.7 mm (0.130 to 0.264 in.) | h | 1.1 to 5.1 mm (0.0433 to 0.201 in.) |
| i | 2.3 to 6.3 mm (0.0906 to 0.248 in.) | j | 4.1 mm (0.161 in.) |
| k | 5.3 mm (0.209 in.) | l | 2.6 to 5.0 mm (0.102 to 0.197 in.) |
| m | -1.2 to 1.2 mm (-0.0472 to 0.0472 in.) | - | - |
2.ADJUST FRONT DOOR
Make sure to turn the ignition switch off before adjusting the door lock strikers.
Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.
Tighten the 4 hinge bolts on the vehicle body after adjustment.
Loosen the 4 hinge bolts on the door and adjust the door position.
Tighten the 4 hinge bolts on the door after adjustment.
Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.
Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.