Home › Engine / Hybrid System › A25A-FKS (EMISSION CONTROL) › EGR VALVE › from 2020.08
RM33A0E _51 Engine / Hybrid System _065344 A25A-FKS EMISSION CONTROL _0328566 EGR VALVE A

A25A-FKS EMISSION CONTROL  EGR VALVE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR valve assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of EGR valve assembly

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)(w/ Canister Pump Module)
(Click here)(w/o Canister Pump Module)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 25680 4.REMOVE EGR COOLER ASSEMBLY

Hide 5.DISCONNECT ENGINE WIRE

a.
A472588C01
0.333,0.073 0.542,0.271 0.208,0.198 10 true *a 3.208,0.323 3.427,0.521 0.219,0.198 10 true *b
*a No. 5 Engine Wire Connector
*b EGR Valve Assembly Connector


Disconnect the No. 5 engine wire connector.


b.

Disconnect the EGR valve assembly connector.


c.

Remove the bolt.


d.

Disengage the 2 wire harness clamps and disconnect the engine wire.


Hide 25601 6.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY

a.
A472589

Using an 8 mm socket wrench, remove the 4 bolts and No. 1 EGR pipe sub-assembly from the intake manifold and EGR valve assembly.


b.
A472576

Remove the EGR valve adapter gasket from the No. 1 EGR pipe sub-assembly.


c.
A402227

Remove the EGR inlet gasket from the intake manifold.


Hide 25620 7.REMOVE EGR VALVE ASSEMBLY

a.
A472577C01
1.719,0.594 1.917,0.25 1.917,0.25 2.188,0.25 true 2.094,2 1.813,2 1.813,2 1.688,1.531 true 2.292,0.167 2.563,0.375 0.271,0.208 10 true *2 2.177,1.917 2.469,2.125 0.292,0.208 10 true *1
*1 No. 8 water by-pass hose
*2 No. 4 water by-pass hose


Slide the clip and disconnect the No. 8 water by-pass hose from the EGR valve assembly.


b.

Slide the clip and remove the No. 4 water by-pass hose from the EGR valve assembly.


c.
A472591

Using an 8 mm socket wrench, remove the 2 bolts and EGR valve assembly from the camshaft housing.