If air does not flow from the front registers after the blower switch on the air conditioning control assembly is operated, the following factors may be the cause.
| Symptom | Factor |
|---|---|
| No air flows from the registers | ·
Air conditioning amplifier assembly malfunction ·
Blower motor with fan sub-assembly malfunction ·
Clogged clean air filter ·
Clogged No. 1 cooler evaporator sub-assembly or heater radiator unit sub-assembly fins ·
Harness or connector |
Operate the blower switch and check that the blower motor with fan sub-assembly can be operated manually.
The blower motor with fan sub-assembly operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Coolant Temperature | Engine coolant temperature | Min.: -40°C (-40°F), Max.: 140°C (284°F) | 75 to 100°C (167 to 212°F): After warming up | This is the engine coolant temperature.
|
| Tester Display |
|---|
| Coolant Temperature |
After warming up the engine, the temperature value displayed is within the range specified in the normal condition column.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for 2AR-FE: Click hereEngine / Hybrid System>2AR-FE (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION