Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP (for A25A-FKS)
RM33A0E _54 Brake _065366 BRAKE SYSTEM (OTHER) _0319135 VACUUM PUMP(for A25A-FKS) G

BRAKE SYSTEM (OTHER)  VACUUM PUMP(for A25A-FKS)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. OPERATION CHECK

a.

Slide the clip and disconnect the union to check valve hose from the vacuum pump assembly.


b.
C373398C01
0.896,1.25 0.896,0.927 true 2.125,0.25 1.781,0.25 true 2.135,0.167 2.313,0.354 0.177,0.188 10 true *a 0.833,1.26 1.021,1.438 0.188,0.177 10 true *b
*a Vacuum Gauge
*b Plug


Connect the hose of the vacuum gauge to the vacuum pump assembly.


c.

Start the engine and warm it up for more than 2 minutes.


d.

With the engine idling, check the vacuum of the vacuum pump assembly.

Standard Pressure:

More than 86.7 kPa (650 mmHg, 25.6 in.Hg)


If the pressure is less than the standard, disassemble and inspect the vacuum pump. If necessary, replace the vacuum pump assembly.

Click hereBrake>BRAKE SYSTEM (OTHER)>VACUUM PUMP (for A25A-FKS)>DISASSEMBLY

HINT:

Always perform this operation check procedure after replacing or servicing the vacuum pump assembly.



e.

Remove the vacuum gauge from the vacuum pump assembly.


f.

Connect the union to check valve hose to the vacuum pump assembly, and slide the clip to secure it.