Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › COMBINATION SWITCH › from 2021.02
RM33A0E _52 Drivetrain _065351 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0342035 COMBINATION SWITCH G

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  COMBINATION SWITCH  INSPECTION  


PROCEDURE

Hide 84390B 1.INSPECT COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

a.

Inspect the NORMAL mode switch:

i.
C307484C29
1.635,1.427 2.01,1.854 true 0.865,1.771 1.198,1.427 true 0.104,0.094 0.417,0.292 0.313,0.198 10 false *a 2.063,1.854 2.635,2.063 0.573,0.208 10 false B 0.667,1.802 1.229,2 0.563,0.198 10 false GND1
*a Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
13 (B) - 16 (GND1) NORMAL mode switch being pushed and held Below 1 Ω
NORMAL mode switch not pushed 10 kΩ or higher


If the result is not as specified, replace the combination switch (electric parking brake switch assembly).



b.

Inspect the SPORT mode switch:

i.
C307484C30
1.802,1.438 2.177,1.865 true 0.865,1.771 1.198,1.427 true 0.104,0.094 0.417,0.292 0.313,0.198 10 false *a 2.24,1.823 2.813,2.031 0.573,0.208 10 false P 0.667,1.802 1.229,2 0.563,0.198 10 false GND1
*a Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
12 (P) - 16 (GND1) SPORT mode switch being pushed and held Below 1 Ω
SPORT mode switch not pushed 10 kΩ or higher


If the result is not as specified, replace the combination switch (electric parking brake switch assembly).



c.

Inspect the illumination:

i.
C307484C31
1.958,1.188 2.594,0.844 true 0.677,0.833 1.302,1.198 true 0.104,0.094 0.417,0.292 0.313,0.198 10 false *a 0.365,0.729 0.927,0.927 0.563,0.198 10 false ILL- 2.656,0.74 3.219,0.938 0.563,0.198 10 false ILL+
*a Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly))


Apply battery voltage to the combination switch (electric parking brake switch assembly) and check that the switch illuminates.

OK:
Condition Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 7 (ILL-)
Illuminates


If the result is not as specified, replace the combination switch (electric parking brake switch assembly).