Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › ACCELERATOR PEDAL › from 2021.02
RM33A0E _51 Engine / Hybrid System _065332 2GR-FKS ENGINE CONTROL _0326382 ACCELERATOR PEDAL A

2GR-FKS ENGINE CONTROL  ACCELERATOR PEDAL  INSTALLATION  


PROCEDURE

Hide 78111 1.INSTALL ACCELERATOR PEDAL

a.
A401222

Engage the claw to install the accelerator pedal.


b.

Install the 2 bolts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 78118 2.INSTALL ACCELERATOR PEDAL PAD

a.

Engage the 4 claws to install the accelerator pedal pad to the accelerator pedal.


Hide 78110K 3.INSTALL ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.

Connect the rod of the accelerator pedal sensor assembly to the accelerator pedal and install the accelerator pedal sensor assembly with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


b.

Connect the accelerator pedal sensor assembly connector.


Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY