Home › Drivetrain › K120 (CVT) › REVOLUTION SENSOR (NT SENSOR) › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461781 REVOLUTION SENSOR(NT SENSOR) G

K120 CVT  REVOLUTION SENSOR(NT SENSOR)  INSPECTION  


PROCEDURE

Hide 89413N 1.INSPECT TRANSMISSION REVOLUTION SENSOR (NT)

a.

Connect the battery to the transmission revolution sensor (NT) as shown in the illustration.

C397726C13
1.448,1.833 1.615,1.417 true 2.083,1.833 1.917,1.417 true 4.083,1.104 4.333,1.354 true 4.625,1.354 4.875,1.604 true 5.854,0.917 6.167,1.073 0.313,0.156 10 false *1 5.125,0.573 5.438,0.729 0.313,0.156 10 false *d 1.208,0.656 1.521,0.813 0.313,0.156 10 false *a 4.646,1.823 4.958,1.979 0.313,0.156 10 false *b 3.781,2.229 4.094,2.385 0.313,0.156 10 false *c 1.313,1.854 1.771,2.052 0.458,0.198 10 false NTB 1.969,1.854 2.427,2.052 0.458,0.198 10 false NTO 3.969,1.021 4.125,1.219 0.156,0.198 10 false 2 4.917,1.552 5.073,1.75 0.156,0.198 10 false 1
*1 Battery - -
*a Component without harness connected
(Transmission Revolution Sensor (NT))
*b Magnet
*c 5 mm (0.197 in.) or less *d Ammeter



b.

Wave a magnet left and right 5 mm (0.197 in.) or less from the tip of the transmission revolution sensor (NT) to output a high/low signal while measuring the current.

NOTICE:

Make sure to wave the magnetic object during the inspection. The current will not change without waving the magnetic object as indicated by the arrow in the illustration.



c.

Measure the current according to the value(s) in the table below.

Standard Current:
Tester Connection Condition Specified Condition
1 (NTO) - 2 (NTB) Low signal 4 to 8 mA
High signal 12 to 16 mA


If the result is not as specified, replace the transmission revolution sensor (NT).