Home › Drivetrain › K120 (CVT) › OIL PRESSURE SENSOR › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461785 OIL PRESSURE SENSOR A

K120 CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.
C395505

Coat the O-ring of the oil pressure sensor with Toyota Genuine CVT fluid FE.

NOTICE:

If reusing the oil pressure sensor, check that the O-ring is not damaged.



b.

Using a 27 mm deep socket wrench, install the oil pressure sensor to the rear transaxle case sub-assembly.

Torque:
20.6 N*m (210 kgf*cm, 15 ft.*lbf)

NOTICE:

Be careful not to damage the O-ring.



c.

Connect the oil pressure sensor connector.


Hide 2.INSPECT FOR FLUID LEAKS