35906
1.INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY
Perform this procedure only when replacement of the indicator light wire sub-assembly is necessary.
| *1 | Connector Housing |
| *a | View A |
|
Shift Position Indicator Terminal |
Install each terminal to the connector housing as shown in the illustration.
Lock the secondary lock.
Engage the claw to install the clamp to the indicator light wire sub-assembly.
Connect the indicator light wire sub-assembly connector.
| *a | Tie Band |
| *b | Guide |
Engage the guide.
Install a new tie band to install the indicator light wire sub-assembly to the shift position indicator.
35978
2.INSTALL SHIFT POSITION INDICATOR
Perform this procedure only when replacement of the shift position indicator is necessary.
Engage the 2 claws to install the shift position indicator to the rear upper console panel sub-assembly.
Install the 2 screws.
Engage the 2 clamps to connect the wire harness.
35974
3.INSTALL LOWER POSITION INDICATOR HOUSING
Engage the 4 claws and 2 guides to install the lower position indicator housing to the shift lock control unit assembly.
Do not damage the lower position indicator housing.