Home › Drivetrain › K120 (CVT) › TCM › from 2021.02
RM33A0E _52 Drivetrain _098634 K120 CVT _0461792 TCM A

K120 CVT  TCM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during TCM removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*1: Not necessary when TCM replaced with new one

Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane Tracing Assist System (Click here)
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
TCM
(If transaxle compensation code read from TCM)
·

Transfer transaxle compensation code

·

Perform reset memory*1

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)
for Initialization
(Click here)
for Registration
TCM
(If transaxle compensation code not read from TCM)
·

Reset transaxle compensation code

·

Perform reset memory*1

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration

·

Perform road test to allow TCM to learn



NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 53737B 3.REMOVE FRONT FENDER APRON SEAL LH

Hide 89535B 4.REMOVE TCM

a.
C447827

Remove the bolt to disconnect the engine wire from the No. 2 transmission control ECU bracket.


b.
C413834C01
0,0 0,0 false
V113147

Rotate in this Direction


Disengage the claw, rotate the lever and disconnect the TCM connector.


c.
C413832

Disengage the clamp.


d.
C413835

Remove the 2 bolts and TCM from the continuously variable transaxle assembly.


Hide 89539M 5.REMOVE NO. 1 TRANSMISSION CONTROL ECU BRACKET

a.
C413836

Remove the 2 screws and No. 1 transmission control ECU bracket from the TCM.


Hide 89539N 6.REMOVE NO. 2 TRANSMISSION CONTROL ECU BRACKET

a.
C413837

Remove the 2 screws and No. 2 transmission control ECU bracket from the TCM.