Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL SOLENOID › from 2021.02
RM33A0E _51 Engine / Hybrid System _098626 M20A-FKS ENGINE CONTROL _0462096 CAMSHAFT OIL CONTROL SOLENOID A

M20A-FKS ENGINE CONTROL  CAMSHAFT OIL CONTROL SOLENOID  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 15370 2.REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

a.
A426534

Disconnect the cam timing oil control solenoid assembly connector.


b.

Using an 8 mm socket wrench, remove the 2 bolts and cam timing oil control solenoid assembly from the No. 2 timing chain cover assembly.

NOTICE:

If the cam timing oil control solenoid assembly has been struck or dropped, replace it.



Hide 3.REMOVE O-RING

HINT:

Perform this procedure only when replacement of the O-ring is necessary.


a.
A401879

Remove the O-ring from the cam timing oil control solenoid assembly.

NOTICE:
·

When removing the O-ring, be careful not to damage the O-ring groove of the cam timing oil control solenoid assembly.

·

If the O-ring groove of the cam timing oil control solenoid assembly is damaged, replace the cam timing oil control solenoid assembly with a new one.