Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › ACTIVE CONTROL ENGINE MOUNT (for Rear Side) › from 2021.02
RM33A0E _51 Engine / Hybrid System _098626 M20A-FKS ENGINE CONTROL _0462101 ACTIVE CONTROL ENGINE MOUNT(for Rear Side) G

M20A-FKS ENGINE CONTROL  ACTIVE CONTROL ENGINE MOUNT(for Rear Side)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 12371A 1.INSPECT REAR ENGINE MOUNTING INSULATOR

a.
A443508

Disengage the 2 clamps to separate the vacuum hose.


b.

Disconnect the vacuum hose.


c.
A443509

Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.


d.

Check that there is no change in the needle movement of the vacuum pump gauge.

OK:

Vacuum pressure holds.



e.

Check that there is no fluid leakage caused by a break in the diaphragm.


f.

Connect the vacuum hose.


g.

Engage the 2 clamps to install the vacuum hose.