Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › ACCELERATOR PEDAL › from 2021.02
RM33A0E _51 Engine / Hybrid System _098626 M20A-FKS ENGINE CONTROL _0462103 ACCELERATOR PEDAL A

M20A-FKS ENGINE CONTROL  ACCELERATOR PEDAL  REMOVAL  


PROCEDURE

Hide 55606 1.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 78110K 2.REMOVE ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY

NOTICE:
·

Avoid physical shock to the accelerator pedal sensor assembly.

·

Do not disassemble the accelerator pedal sensor assembly.

·

The accelerator pedal sensor assembly does not require lubrication.

·

Do not apply oil or other lubricants to the accelerator pedal sensor assembly. If applied, the accelerator pedal sensor assembly must be replaced.



a.
A408652C01
0,0 0.313,0.26 0.313,0.26 12 true *A 0.01,2.396 0.344,2.646 0.333,0.25 12 true *B
*A for TMC Made
*B except TMC Made


Disconnect the accelerator pedal sensor assembly connector.


b.

Remove the 3 nuts and disconnect the rod of the accelerator pedal sensor assembly from the accelerator pedal to remove the accelerator pedal sensor assembly.

NOTICE:

If the accelerator pedal sensor assembly has been struck or dropped, replace it.



Hide 78118 3.REMOVE ACCELERATOR PEDAL PAD

a.
A401219

Disengage the 4 claws and remove the accelerator pedal pad from the accelerator pedal.


Hide 78111 4.REMOVE ACCELERATOR PEDAL

a.
A401220

Remove the 2 bolts.


b.
A401221C01
2.302,1.896 2.302,1.583 false 2.313,3.146 2.313,2.833 false 2.24,1.896 2.552,2.052 0.313,0.156 10 false *a 2.25,3.146 2.563,3.302 0.313,0.156 10 false *a
*a Vehicle Body
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Push the accelerator pedal in the direction indicated by the arrow (1) shown in the illustration to disengage the claw.


c.

Pull the accelerator pedal in the direction indicated by the arrow (2) shown in the illustration to remove it.