Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › from 2021.02
RM33A0E _51 Engine / Hybrid System _098626 M20A-FKS ENGINE CONTROL _0462108 ENGINE COOLANT TEMPERATURE SENSOR A

M20A-FKS ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 89422A 2.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A443523

Disconnect the engine coolant temperature sensor connector.


b.
A443524

Remove the clip and engine coolant temperature sensor from the water outlet.

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.